Delete all timing data…
Put the race's timing desk back to its clean original state for the chosen runs.
What it's for
Delete all timing data empties the timing desk of the active race for the runs you tick: every impulse, every saved time and every status set at the desk goes, and the desk's start order goes back to the draw. Use it after a test run on a throwaway race, or to start a run again from nothing.
Before you start
- The ACTIVE RACE picked in the header. The dialog names the race it will clear.
Steps
- Open Timing Desk › Delete all timing data… in the Data group of the rail.
The race, the runs, and OK — delete - Tick the runs to clear: Run 1, Run 2.
- With more than one timing window, pick the window's tab. Window 1 holds the race's timing; an added window's devices are not attached to the race, so it has nothing to delete here and says so.
- Press OK — delete.
What success looks like
The desk shows the run 1 start list as drawn, with no impulses and no times, and Data Management's counters read 0 for everything but List.
If something goes wrong
- This cannot be undone here. The timing devices keep their own copy of every press, and a gap fill brings back only presses taken while the light was green and not deleted; a deleted press never returns.
- Impulses came back after a delete (a replay or a download): the delete is enforced again and the row says so. Lift the delete on Data Management's Deletes on this race list only if you meant to bring them back.
Related
- Previous: Delete selected…
- Next: Results & publish
- How it fits: Run 2, from the last Run 1 finish to the results
- Data Management
Was this helpful?